| GRADE |
TYPE |
DESCRIPTION |
APPLICATIONS |
Ultimet 16
|
Duplex |
High temperature vacuum sintered to near full density (7.7 g/cm3) providing material structurally comparable to cast CF-3M with corrosion properties competitive with wrought 316 stainless steel |
Food industry components and pump rotors
in corrosive environments |
Ultimet 16 GR
|
Duplex |
Ultimet 16 with a wear resistant additive to provide increased resistance to galling compared to Cast 316 or Ultimet 16 |
Components subject to galling wear |
Ultimet 440C
|
Martensitic |
High temperature liquid phase sintered to near full density (7.6 g/cm3 after heat treating) to provide a distribution of large carbides in a martensitic matrix for wear resistance |
Grinder plates, plungers, and other corrosion resistant wear components |
| GRADE |
TYPE |
DESCRIPTION |
APPLICATIONS |
D2
|
Cold-Work Tool Steel |
High temperature liquid phase sintered to near full density. The fine, homogeneous carbide distribution provides good wear resistance below 400 °F (200 °C). |
Wear resistant components such as knife blades, slitters, choppers, dies and punches. |
M2
|
High Spped Steel |
High temperature liquid phase sintered to near full density. The fine, homogeneous carbide distribution provides excellent grindability compared to wrought or cast M2. |
Severe wear resistant components such as cam rings, pump liners, seals, and plungers |
T15
|
High Spped Steel |
High temperature liquid phase sintered to near full density. The fine, homogeneous carbide distribution provides excellent grindability and hot hardness. |
Spade drill bits, cutting inserts, and wear plates |